AVS Ventvisor Serie Instructions D'installation page 2

Installation Steps Front Air Dam Installation Steps
Clean the window channel
1
Insert visor into window channel,
rear flange first. Rear flange inserts
between the trim and the exterior
surface. The front & top flange slides
into the window channel.
3
4 Piece Set
Install the rear visors using the same preparation and installation methods as the front visor.
Note that the rear flange adheres to the outside of the window post, and the front flange inserts
5
NOTE: Actual application may vary slightly from illustrations.
with an alcohol pad.
Peel back 2" of tape line from each end of top flange.
2
Remove tape liner by pulling on the free ends. Raise
window slowly and leave up for 24 hours to secure visor
4
between the rubber & window frame.
Page 2 of 3
free end
top flange
rear flange
front
flange
to window channel.