Safety Regulations - realspace Magellan Performance Serie Instructions Pour L'assemblage Et Information Sur La Garantie

Safety regulations

Keep children away from electric height-adjustable tables, control units and operation
panel. There is a risk of injury and electric shock.
Plug the Power Cord into a 120v outlet only.
Table working temperature: 41°F -104°F (5°C - 40°C).
Do not connect electric devices to the control box over the maximum total output of 1176 W/9.8 A.
Motor for height adjustment may be run continuously for max. 3 min. and then must stand by for
27 min. before being used again.
Make sure no objects are in the way of table while adjusting height; do not place any objects
taller than 20" underneath the desk.
Make sure the desktop is not touching any walls.
Always remove chairs before the table is moved up/ down. Table must not bump into any fixed
objects.
Make sure all cords are appropriate length to accommodate the change in height.
RISK OF FIRE: Table is for indoor use only in a dry area. Never spray aerosol products or
flammable liquids on or near the motor for the height adjustment of the table due to risk of fire.
Keep all cords and all electrical components away from heated surfaces or areas.
Never operate this table if a damaged cord or plug is observed.
Alterations to all the components are absolutely forbidden.
Do not open any of the components- the legs, control box, operation panel. There is a danger of
electric shock.
Do not open electrical device while plug in.
Do not repair electrical device while plug in.
The power cord must be unplugged from the outlet before and during all service and repair work
of the table.
The table must not be loaded over 200lbs.
Do not sit or stand on the table. Must not be used as a lifting device for persons.
When the table is moving, keep all persons and objects a safe distance away to avoid the risk of
being injured or damaged by getting squeezed between the moving table and fixed objects in
the surrounding area.
Always unplug from the power outlets and/or USB ports on the control box when electrical
devices are not being used.
Unplug all power before relocation or parts replacement.