Kaco blueplanet 87.0 TL3 Mode D'emploi page 186

Shortsign (en) Shape of the connector
External hex
W
Internal hex
A
Torx
T
Slot
S
Tab. 1: Key and description of tool codes
3.3 Fastening the mount
WARNING
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be seri-
ously injured.
› Use only fixing materials that are suitable for the mounting base. The fastening materials supplied are
only to be used for masonry and concrete.
› Only install the device in an upright hanging position.
4 Installation
4.1 Opening the device
↻ The device has been installed on the mount.
↻ Wipe any moisture off the frame of the housing cover using a cloth.
1 Undo the 6 screws (2) and carefully remove the housing cover (1) [
2 Be careful not to damage or soil the seals or optical fibers when setting the
housing cover down.
» Proceed with the installation of the device.
4.2 Making the electrical connections
NOTE
Select conductor cross-section, safety type and safety value in accordance with the following basic condi-
tions:
Country-specific installation standards; power rating of the device; cable length; type of cable installation;
local temperature
Detailed information on tightening torques: See comprehensive operating instructions under
ergy.com/de/downloads
4.3 Connecting the device to the mains supply
4.3.1 Preparing the grid connection
Page 186
Tightening torque
Spanner size or number
Outer contour
Fig. 1: Presentation format
T_25]
Fig. 2: Removing the housing
cover
Photovoltaic feed-in inverter - KACO blueplanet 87.0 - 165TL3
in-Ibs
1
2
http://www.kaco-newen-