Sensor Status & Editing - Bresser 7003500 Mode D'emploi

f Wind direction
g Light
h Skin type
4.9.5 SENSOR STATUS & EDITING
Sensor name column,
you can name your
sensor in setup UI
Channel number
column
4.9.5.1 ADD NEW SENSOR
1. In this section, press
2. Press key to select the edit sensor column and it will show "Add?".
3. Press key to start search the sensor.
4. In the meantime, select the channel in the sensor, then power up the sensor or press reset key of the
sensor to start pairing.
5. Once connected, the sensor icon, ID and signal strength will show on the channel row.
4.9.5.2 DELETE CURRENT SENSOR
1. In this section, press
2. Press key to select the edit sensor column and it will show "Delete?".
3. Press key to delete the sensor.
4.9.5.3 CHECK SENSOR STATUS
1. In this section, press
2. Press key twice to select the sensor type icon
3. Press the key again to show the sensor connection status as below:
Press / to select 16 direction or 360˚
Press / to select Klux, Kfc or W/m²
Press / to select Light, Medium or Dark skin type for exposure level
/ key to select the empty channel.
/ key to select the connected sensor.
/ key to select the connected sensor.
77
Sensor ID column
Sensor type column
Edit sensor column
EN