Smart Ventilating Fan; Install Batteries; Multisensor Installation - Bresser 7003500 Mode D'emploi

3.1.1

SMART VENTILATING FAN

A ventilating fan is installed inside the radiation shields to reduce the impact of sun heat effect. The fan is
driven by solar panel and will automatically start spinning under 2 conditions:
1. When the sun is shining on the solar panel, and 2. Average wind speed is below 5m/s for 1 minute.
3.1.2

INSTALL BATTERIES

Unscrew the battery door at bottom of unit. Insert the
3xAA batteries (non-rechargeable) according to the +/-
polarity indicated. The red LED indicator on the back of
the Multisensor will turn on, and then begin flashing every
12 seconds.
NOTE:
- Once the batteries installed correctly, the red LED will begin
flashing every 12 seconds.
- We recommend using non-rechargeable Lithium AA batteries
for cold weather climate, but normally Alkaline batteries are
sufficient for use in most weather condition.
3.1.3

MULTISENSOR INSTALLATION

MOUNTING KIT INSTALLATION
1. U-bolt x 2
Stainless steel pole placed
under the egg tray, please
check before disposal of
V entilating fan
2. Pole mounting
clamps x 4
Note:
the packaging.
3. Flat washers x 4 4. Hex nuts x 4
58
Screw
location
3 x AA
batteries
5. Stainless steel pole