Télécharger Imprimer la page

Milnor Mark II Fonctionnement page 8

Masquer les pouces Voir aussi pour Mark II:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4UcSbY`dY_^_V3_^db_\c±=Qb[99
CdQ`X7eQbTGQcXUb5hdbQSd_b
Hold this switch to
first compartment of the supply injector.
Hold this switch to
nozzle to clean the supply injector.
Press this button to flush the chemical
supply manifold with fresh water.
Set this switch to
functions and hold the drain closed. The machine can be powered off with the drain closed
for overnight soaking. Set to
Set this switch to
to
to use internal machine formulas.
causes the Ampsaver controller to delay extraction when necessary to prevent the
amperage drawn by all machines from exceeding a preset maximum.
Ampsaver controller from affecting machine operation.
This switch selects a cylinder pocket to spot (Autospot) or
a direction of rotation for inching (Inch).
Soil Side—When a pocket is selected, pressing
spots the cylinder.
Clean Side—Pressing inch button
Pressing this button
buttons are released (inching) or the cylinder reaches the
position selected with the Autospot/Inch Selector switch
(Autospot).
This button transfers control from the clean side to the soil side if a formula is not running
and the clean side outer door is closed.
' ' ;:5
;:59 9 6 6 5
5 :
:
This light illuminates when the cylinder stops at the position selected with the
Autospot/Inch Selector switch.
to flush water into the
to use the spray
to disable all machine
to permit normal operation.
to have the machine communicate with the Mildata computer. Set
inches the cylinder.
rotates the cylinder until the
4
=C?E@C3D15)$##1F#$
prevents the

Publicité

loading