Télécharger Imprimer la page

Milnor Mark II Fonctionnement page 14

Masquer les pouces Voir aussi pour Mark II:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

>_b]Q\?`UbQdY_^±=Qb[99
CdQ`X7eQbTGQcXUb5hdbQSd_b
wheel to tighten the door seal. Swing the door closed with enough force to latch it.
NOTE: Closing the door sounds the operator signal if a formula was previously selected.
depending on the optional hardware furnished and the formulas used. The possible methods are as
follows:
Automatically inject chemicals with a pumped chemical or central liquid supply system.
Load the supply injector before starting the cycle. Supplies are flushed in automatically.
Re-load supply injector compartments or manually flush compartment one during the cycle,
when prompted by the formula.
Pour supplies through the soap chute before or during the cycle.
Because the injection method, formulas, and chemicals to be used are determined in the field,
the operator procedures for adding chemicals are determined locally. See the reference manual for
further information on the optional supply injector, liquid supply injection, and formulas.
The available formulas are listed in the Run Formula menu.
When the operator signal is sounding (door closed and formula selected), press
the Start button (
).
Models 420xxWPx, 420xxSPx only—Turn the hand
Chemical supplies may be added manually or automatically,
If the machine is on-line to a Mildata computer, see "Enter Cake Data."
Enter a formula number (two digit number from 01 to 98) or scroll through
the available formulas by pressing
for information on permanent formulas 00 and 99.
Appears if a non-existent formula is selected.
10
=C?E@C>?15)$##1F%'
or
. See the reference manual

Publicité

loading