Milnor Mark II Fonctionnement page 15

>_b]Q\?`UbQdY_^±=Qb[99
CdQ`X 7eQbTGQcXUb 5hdbQSd_b
also sound during the cycle if operator attention is required. Check the display.
formula is in progress and immediately after manually terminating a formula. Models 420xxWPx and
420xxSPx only—Turn the hand wheel to loosen the door seal. Hold the Door Open button (
door plunger retracts, pull the door until it clears the latch, then release
NOTE: Opening the door silences the operator signal.
wheel to tighten the door seal.
and unloaded on the other side (clean side). Both sides have operator controls, but only one set of
controls responds at any time. The Soil Side status light (
to both operators which side has control. During the cycle, control is at the soil side. When the cycle
ends, control is automatically transferred to the clean side. After unloading, the clean side operator must
return control to the soil side.
With the clean side outer door closed (must be closed to transfer control), press the Release
button ( ) and verify by the status lights that control has returned to the soil side.
The operator signal will sound when the cycle ends. It may
The cycle is completed.
"TUMBLING"—If desired, open the door, pull the goods down, close the
door, then press the Start button (
"REVERSING" or "DRAIN SPEED"—Press the Signal Cancel button (
to stop cylinder motion and complete the cycle.
Safeguards prevent the door from opening while a
Models 420xxWPx, 420xxSPx only—Turn the hand
Staph-Guard models are loaded on one side (soil side)
=C?E@C>?15 )$##1F& '
) to continue tumbling for two minutes.
. Open the door completely.
) and Clean Side status light (
11
)
). When
) indicate