Assembly - Greencut GLM560L-20 Manuel D'utilisation

58

ASSEMBLY

UNFOLDING AND ADJUSTING LOWER HANDLE
ATTENTION: Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
Do not damage the cables when folding or unfolding the handle.
If a cable is damaged, contact an Authorised Service Centre.
UNFOLDING AND ADJUSTING HANDLE ASSEMBLY
a. To raise handle assembly:
• Pull up and back on the lower handle (1) until it is
aligned with the hole position of the arm support and
the mower housing.
• To secure the lower handle (1) in place, lock the lower
screw (3).
• Open the upper cam locks (2).
• Pull up and back on the upper handle to raise it into
operating position.
• To secure the upper handle in place, close the upper
cam locks (2).
NOTE: If the upper handle is loose or
separated from the lower handle, tighten
the knobs on the upper handle locks by
turning them clockwise.
INSTALLING THE GRASS CATCHER BAG
• Lift the rear disc harge door (1).
• Lift the grass catc her by its handle (2) and place under
the rear disc harge door so that the hooks (3) on the
grass catc her are seated on the door rod (4).
• Release the rear disc harge door. When installed
correctly, the hooks on the grass catcher will extend
through the openings on the rear disc harge door.
NOTE: When using the grass catcher, do
not install either the side discharge
deflector or the mulching plug.
1
1
2
2
3
4
3