Assembly; Handlebar Assembly - Greencut GLM1400C Manuel D'utilisation

ASSEMBLY

ATTENTION: Do not connect the machine to the power supply until assembly is complete. Failure
to comply could result in serious injury.

HANDLEBAR ASSEMBLY

1. Insert the bottom bars into the holes in the cover at the ends. Make sure the mounting holes of the bottom
bars are aligned with those of the brackets.
2. Secure the bottom rails with the screws and washers.
1
3. Insert the cable tie through the top handle.
4. Place the upper handle over the lower handle, align the holes and tighten the bolts and knobs to hold it.
INSTALLATION OF THE COLLECTION BASKET
1. Open the protective cover and hold it in this position.
2. Align the brackets on the grass catcher frame with the hooks to hang it (M).
3. Release the deflector guard.
4. To remove the collection basket, lift the rear protective cover and lift the collection basket to unhook it from
the mower. Once removed, pull the collection basket and lower the rear cover.
M
2
51
EN