Interlocked Setting - Mitsubishi Electric PAC-SC30GRA Manuel D'utilisation

7-1-2. Interlocked setting

• Sets each group for Interlocked operations with Interlocked unit.
• Perform the settings for the Interlocked unit after the groups have been set. Interlocked unit cannot
be set up for groups that do not have any units registered.
1 Call out the Interlocked unit setting screen
↓
2 Select the group number
Select the group for which interlocked unit is to be registered in the same way as for retrieval and
deletion.
3 Call out the registered unit
↓
4 Select the interlocked unit address number
↓
5 To register interlocked units
6 To delete interlocked units
7 To confirm interlocked units
↓
Refer to 7-1-1 or 7-1-3.
1 Call out the interlocked unit setting screen
(1) Change the screen from the group selection screen shown in 7-1-1 1 to the interlocked unit setting
screen.
Press the
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
Initial settings mode screen
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
Interlocked unit setting screen
2 Select the group number
(1) Call out the group number
• Call out the group number into which the interlocked unit is to be registered. Perform the same
procedure as explained in 7-1-1. 1 group selection.
• Select the group with the
(2) The relevant group number will be displayed in the room temperature display area once the group
has been selected.
18
operation mode switch.
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
and
[ ] will be displayed two
seconds later
The screen will switch between the initial settings
mode screen and the interlocked unit setting screen
whenever the
pressed.
[ ] will be displayed two
seconds later
Display area for the interlocked
unit address number
GROUP select switch.
operation mode switch is