Initial Settings; Setting The Master Controller - Mitsubishi Electric PAC-SC30GRA Manuel D'utilisation

7. Initial settings

7-1. Setting the master controller

It is necessary to enter initial settings. The initial settings include the following:
7-1-1. Group settings
7-1-2. Interlocked setting
In order to perform these operations, first of all display the initial settings on the remote controller's
screen.
1 The following will be displayed when power is supplied to the remote controller.
(i) If the group setting information has not been registered:
CENTRALLY CONTROLLED
CHECK
ADDRESS ON
˚C
COLLECTIVE
GROUP
(ii) The following is displayed when group setting information already exists.
CENTRALLY CONTROLLED
CHECK ADDRESS ON
˚C
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
CHECK
ADDRESS ON
˚C
COLLECTIVE
GROUP
2 Display the initial setting mode screen.
When 1 (i) [H0] blinks in the remote controller's screen or when the user operation screen 1 (ii) is
displayed, press the FILTER sign reset and
two seconds). Be sure to perform this operation after first turning off the air conditioners for the entire
group using the collective ON/OFF switch in the user operation screen 1 (ii).
Also, switch operations are disabled if the
and perform normal operations once the
CENTRALLY CONTROLLED
CHECK
ADDRESS ON
˚C
COLLECTIVE
GROUP
Initial setting mode screen
Perform operations 7-1-1 to 7-1-4 once the above status has been reached.
ON/OFF
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
ON/OFF
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
ON/OFF
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
7-1-3. Canceling the initial setting mode
7-1-4. Collective deletion
[H0] in the room temperature display area and the overall
status lamp will blink.
[H1] will blink in the room temperature display area
during system start-up communications.
The user operation screen will be displayed when system
start-up communications have been completed.
horizontal blow switches simultaneously (for at least
display is illuminated. Press the
display has been extinguished.
external timer switch
13