Mitsubishi Electric PAC-SC30GRA Manuel D'utilisation page 20

5 To register interlocked units
(1) Press the TEST RUN switch with the details explained in 4 displayed to register the interlocked unit
into the group.
• The following will be displayed if registration was performed normally.
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
CHECK ADDRESS
˚C
COLLECTIVE
GROUP
[ ] will blink beside the unit type if the registration was not performed normally.
(2) Registering other units
• Select other groups with the use of the
• Select the indoor unit into which the interlocked equipment is to be registered with the
operation mode switch.
• Select the other interlocked unit with the
By performing the above procedure, the interlocked unit address number selection screen shown in
4 will be displayed to allow the set-up of subsequent interlocked unit.
6 To delete interlocked units
Deletes the interlock settings for indoor units and interlocked unit.
(1) Display the screen following interlocked unit set-up or the retrieval screen for interlocked unit.
CENTRALLY CONTROLLED
CHECK ADDRESS
˚C
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
CHECK
ADDRESS
˚C
COLLECTIVE
GROUP
20
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
The range of settings for address numbers
and attributes for the interlocked units are:
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
ON OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
The contents of the display will alternate between the
information for the indoor unit's set address number
and that of the interlocked unit's address number.
and GROUP select switch.
air direction and external timer switch.
Alternately
001 to 050,
LC or FU