Mitsubishi Electric PAC-SC30GRA Manuel D'utilisation page 19

(3) Once the group has been selected, the unit with the smallest address number will be displayed if
registered units exist for that particular group.
Details displayed:
Temperature setting display area: Address number
Room temperature display area: unit type
Example: When group 1 is not registered and an indoor unit with the address 003 is registered
in group 2.
CENTRALLY CONTROLLED
CHECK
ADDRESS ON
˚C
COLLECTIVE
GROUP
CENTRALLY CONTROLLED
CHECK
ADDRESS ON
˚C
COLLECTIVE
GROUP
3 Call out the registered unit
Call out the indoor unit's address number for which interlocked unit is to be registered by pressing the
switch.
ON/OFF
4 Select the interlocked unit address number
Call out the interlocked unit address number to be registered in the indoor unit selection in 3.
air direction setting switch with the indoor unit selected in 3 displayed.
(1) Press the
• The displayed interlocked unit address numbers will change in the following sequence whenever the
switch is pressed.
" " "
• Press the external timer switch to change the display in the opposite direction.
CENTRALLY CONTROLLED
CHECK ADDRESS ON
˚C
COLLECTIVE
GROUP
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
" "
• • • • •
˚C
OFF
GROUP
FILTER
CHECK MODE
TEST RUN
NOT AVAILABLE
[ ] will be displayed two
seconds later
(interlocked unit setting screen)
Press once.
[ ] or ohter unit type will be
displayed two seconds later.
Group 2 selection
"
Aligned with the address number of
the interlocked unit to be registered.
19