Videotec ULISSE RADICAL Manuel D'instructions page 30

9.1.12 Camera Settings page
The change in data in the "Protocol and
authentication" section could make the
camera inaccessible. The data set by default
allow correct access to the system.
You are advised not to change the data
in the "Lenses Features" section to avoid
prejudicing correct system operation.
The only useful field for the end user is
"Autofocus".
This section displays the data for the different ONVIF
profiles exported from the camera.
Fig. 65
28
To edit the camera settings, select the VTTunnel
button or simply the Camera button in the tools
menu (9.1.13 Tools Page, page 28).
9.1.13 Tools Page
If resetting, the PTZ is restored to default
conditions. To access the system, following
the instructions in the relevant chapter (9.1
Web interface, page 21).
From menu entry Tools it is possible to re-set the
predefined values for the entire configuration of
device or only for a number of specific sections.
This section:
• Update the firmware of the device.
• Restart the device.
• Download the VTTunnel application to enable the
connection with the IP camera needed to access its
web page. (9.2 VTTunnel, page 30).
• Open the web pages of the camera (9.3 Camera,
page 30).
Fig. 66
MNVCUPKHXL_2222_EN