Toro PowerMax Heavy Duty 1028 OHXE Manuel De L'utilisateur page 24

Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
auger/impeller cable and adjust it if
necessary.
Yearly—Inspect the auger/impeller cable and
adjust or replace it if necessary.
1. Remove the 2 screws that are holding the belt
cover in place (Figure
2. Remove the belt cover
Figure 34
3. With the auger/impeller lever disengaged,
ensure that the gap between the auger clutch
arm and the frame of the machine is 1.5 mm
(1/16 inch) as shown in
Figure 35
1. 1.5 mm (1/16 inch)
2. Frame
4. If the auger/impeller cable is not properly
adjusted, do the following steps:
5. Loosen the jam nut
34).
(Figure 34).
Figure 35.
3. Auger clutch arm
(Figure 36).
1. Jam nut
6. Loosen or tighten the turnbuckle that adjusts the
tension on the cable
7. Adjust the turnbuckle until you obtain the proper
gap.
8. Tighten the jam nut.
9. Insert the 2 screws that you previously removed
on the belt cover.
10. If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
g260066
Service Dealer.
g260108
22
Figure 36
2. Turnbuckle
(Figure 36).
g322960