Husqvarna 525LK Manuel D'utilisation page 12

Coupe-bordures équipé d'un moteur à combustion
Masquer les pouces Voir aussi pour 525LK:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Husqvarna alkylate fuel
We recommend you to use Husqvarna alkylate fuel for
best performance. The fuel contains less dangerous
material compared to regular fuel, which decreases
dangerous exhaust fumes. The fuel gives a low quantity
of dangerous remainings when it is combusted, which
keeps the components of the engine more clean. This
extends the life of the engine. Husqvarna alkylate fuel is
not available in all markets.
Two-stroke oil
CAUTION:
and/or incorrect oil/fuel ratio can damage the
product and decrease the life time of
catalytic converters.
CAUTION:
water-cooled outboard engines, also
referred to as outboard oil.
CAUTION:
engines.
For best results and performance use Husqvarna
two-stroke oil.
If Husqvarna two-stroke oil is not available, use a
different two-stroke oil of good quality for air-cooled
engines. Speak to your servicing dealer to select the
correct oil.
Gasoline, l
5
10
15
20
To mix gasoline and two-stroke oil
CAUTION:
errors influence the ratio of the mixture
drastically when you mix small quantities of
fuel. Carefully measure the quantity of oil to
be mixed to make sure that you get the
correct mixture.
12
Unsatisfactory oil quality
Do not use two-stroke oil for
Do not use oil for four-stroke
Two-stroke oil, l
2% (50:1)
0.10
0.20
0.30
0.40
There is a risk that small
1. Fill half the quantity of the gasoline to be used.
2. Add the full quantity of oil and mix (shake) the fuel
mixture.
3. Add the remaining quantity of gasoline.
4. Carefully mix (shake) the fuel mixture and fill the fuel
tank of the product.
5. Empty and clean the fuel tank if you do not use the
product for some time.
Note:
Do not mix fuel for more than 1 month at a time
and always mix gasoline and oil in a clean container
intended for fuel.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed. Use a fuel container with an anti-spill
valve.
3. Fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m (10 ft) or more away from the
refueling area and fuel source before starting.
CAUTION:
causes malfunction. Clean the fuel tank and
chain oil tank regularly and replace the fuel
filter one time a year or more.
Before you operate the product
Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
Contamination in the tanks
1027 - 001 - 23.04.2019

Publicité

Table des Matières
loading

Table des Matières