Electrolux ESL5201LO Notice D'utilisation page 34

Masquer les pouces Voir aussi pour ESL5201LO:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

34
www.electrolux.com
Problem and alarm code
The appliance does not fill with wa-
ter.
• The end indicator flashes 1 time
intermittently.
• Acoustic signal sounds 1 time in-
termittently.
The appliance does not drain the wa-
ter.
• The end indicator flashes 2 times
intermittently.
• Acoustic signal sounds 2 times in-
termittently.
The anti-flood device is on.
• The end indicator flashes 3 times
intermittently.
• Acoustic signal sounds 3 times in-
termittently.
The appliance stops and starts more
times during operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to
close.
Rattling/knocking sounds from inside
the appliance.
The appliance trips the circuit-beak-
er.
Possible cause and solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is
not clogged.
• Make sure that the inlet hose has no kinks or
bends.
• Make sure that the sink spigot is not clog-
ged.
• Make sure that the drain hose has no kinks
or bends.
• Close the water tap and contact an Author-
ised Service Centre.
• It is normal. It provides optimal cleaning re-
sults and energy savings.
• If the delayed start option is set, cancel the
delay setting or wait for the end of the count-
down.
• The appliance is not level. Loosen or tighten
the adjustable feet (if applicable).
• The appliance door is not centred on the tub.
Adjust the rear foot (if applicable).
• The appliance is not level. Loosen or tighten
the adjustable feet (if applicable).
• Parts of the tableware are protruding from
the baskets.
• The tableware is not properly arranged in the
baskets. Refer to basket loading leaflet.
• Make sure that the spray arms can rotate
freely.
• The amperage is insufficient to supply simul-
taneously all the appliances in use. Check the
socket amperage and the capacity of the
meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Con-
tact an Authorised Service Centre.

Publicité

Table des Matières
loading

Table des Matières