Technical Data - Anslut 015181 Mode D'emploi

EN
by, or near children or persons with
functional disorders.
• Do not put any foreign objects on the
product.
• Never poke your fingers or any other
objects into the inlet or outlet openings.
• Do not use the product near a bath,
shower or swimming pool.
• Do not cover the product, this can result
in overheating.
SYMBOLS
Read the instructions.
Do not cover.
Approved in accordance with
the relevant directives.
Recycle discarded product
in accordance with local
regulations.

TECHNICAL DATA

Rated voltage
Output
Power settings
Overheating protection
Safety class
Protection rating
Size
Weight
DESCRIPTION
1. Status light
2. Thermostat dial
3. Mode selector
4. Fan mode
5. Low output mode + fan
6. High output mode + fan
FIG. 1
18
230 V ~ 50 Hz
2000 W
25/1000/2000 W
65°C
I
IP20
21 x 16 x 21.7 cm
1.7 kg
USE
BEFORE USE
1. Unpack the product and all the parts from
the packaging and place them on a level
surface.
2. Check that the mains voltage corresponds
to the rated voltage on the type plate. Plug
in the plug. The product is now ready to use.
IMPORTANT:
• Do not place the product near walls or
corners, where incoming or outgoing air
can be blocked.
• Do not place the product directly below
a power outlet.
HOW TO USE
1. Place the product standing upright on
a level, stable surface at a safe distance
from flammable objects and substances.
2. Plug the plug into the power point.
3. Set the thermostat dial to the required
mode.
4. Start the product by setting the mode
selector to the required output.
5. The heating element switches off when
the set room temperature is reached,
including the fan. The heating element
and fan start again when the temperature
drops . The product starts and switches
off automatically to maintain a constant
room temperature.
6. To switch off the product, set the
thermostat to MAX and put the mode
selector in fan mode. Allow the product to
run for two minutes to cool and then switch
off the product and pull out the plug.
MAINTENANCE
NOTE:
Switch off the product, pull out the plug, and
wait until the product has completely cooled
before cleaning and/or maintenance.