Bosch RIDE+ Performance Line Manuel Du Propriétaire page 72

6
5
4
Options for switching off the eBike system:
– Press the On/Off button 5 of the on-board computer.
– Switch the eBike battery pack off by using its On/Off
button (see battery pack operating instructions.)
– Remove the on-board computer out of its holder.
If the eBike is not moved and no button is pressed on the
on-board computer for 10 minutes, the eBike system will
shut down automatically in order to save energy.
eShift (optional)
eShift is the integration of automatic gear shifting systems
into the eBike system. To support the rider in the best way
possible, the function indications and the basic settings
menu have been adapted for the "eShift" function.
eShift with NuVinci H|Sync
The optimum gear for the respective speed is automatically
set according to a pre-defined desired cadence. In manual
mode you can choose between multiple gears.
In the " NuVinci Cadence" mode you can use the "–" or
"+" button on the operating unit to increase or decrease the
desired cadence. If you hold down the "–" or "+" button,
the cadence will increase or decrease in steps of five. The
desired cadence is shown on the display.
In the " NuVinci Gear" mode you can use the "–" or "+"
button on the operating unit to switch back and forth be-
tween several defined transmission ratios. The engaged
transmission ratio (gear) is shown on the display.
Bosch eBike Systems
1
2
3
eShift with SRAM DD3 Pulse
The gear hub of the SRAM DD3 Pulse works on a speed-de-
pendent basis. Regardless of which gear is engaged on the
derailleur gears, one of the three gears of the gear hub will
automatically be engaged (" Autom. Gear Selection").
The engaged gear will be shown briefly on the display when-
ever the gear of the gear hub is shifted.
If the eBike is brought to a standstill from a speed of more
than 6 mph, the system can automatically switch back to a
set "Start gear". The "Start gear" can be set in the basic
settings menu (see "Displaying/Adapting Basic Settings"
on page English–10).
In the " Gear" mode you can use the "–" or "+" button on
the operating unit to switch back and forth between several
defined transmission ratios. The engaged transmission ra-
tio (gear) is shown on the display.
In the " Gear" manual mode, the system can also auto-
matically switch back to a set "starting gear".
The drive unit recognizes the gear shift and briefly reduces
the motor assistance level as a result of it, which means the
gear can also be shifted at any time under load or on a hill.
eShift with Shimano Di2
For Shimano eShift you use the Shimano control lever to
shift gears.
The engaged gear will be shown briefly on the display when-
ever the gear of the gear hub is shifted.
The drive unit recognizes the gear shift and briefly reduces
the motor assistance level as a result of it, which means the
gear can also be shifted at any time under load or on a hill.
If the eBike is brought to a standstill from a speed of more
than 6 mph, the system can automatically switch back to a
set "Start gear". The "Start gear" can be set in the basic
settings menu (see "Displaying/Adapting Basic Settings"
on page English–10).
71
English–6
1 270 U20 XBI | (20.4.16)