Hilti WSR 36-A Mode D'emploi page 25

Noise information
Sound (power) level (L
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration information
Vibration emission value for sawing chipboard (a
Vibration emission value for sawing wood beams
(a )
h,WB
Uncertainty (K)
5 Operation
5.1 Safe operation 2
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
WARNING
Risk of injury! Danger of kickback.
▶ Always use saw blades of adequate length. The tip of the blade must project at least 40 mm (1¹/₂")
beyond the reverse side of the workpiece during the blade stroke.
WARNING
Risk of injury! Caused by the chuck / accessory tool retaining mechanism
▶ Always hold the power tool securely with both hands on the grips provided. Never use the power tool
without a fully functional hand guard.
WARNING
Risk of injury by the blade holder / chuck
▶ Do not use the cover over the blade holder / chuck as a gripping area.
The power tool must be pressed against the workpiece until the contact shoe makes firm
contact. This helps ensure maximum safety and good performance.
▶ Observe all safety instructions printed in this documentation and on the tool.
5.2 Removing the battery
1. Press the two release buttons and hold them in the pressed position.
2. Pull the battery out of the product to the rear.
5.3 Fitting the saw blade
Use only saw blades equipped with a 1/2" connection end.
1. Engage the transport lock.
2. Check that the connection end of the accessory tool is clean and lightly greased. Clean it and grease it if
necessary.
*214009*
)
WA
)
WA
)
pA
)
pA
3
4
214009
WSR 36­A
101 dB(A)
3 dB(A)
90 dB(A)
3 dB(A)
WSR 36­A
) 13 m/s²
h,B
16 m/s²
1.5 m/s²
English 19