dirna Bergstrom bycool green line COMPACT 1.4 Instructions De Montage page 27

COMPACT 1.4
Take the power supply cable from the equipment through to the vehicle battery, attaching the
1
plastic supports to the rear of the cabin and securing with flanges; then, with the cabin tilted,
pass the cable through the bottom, securing it with clamps and M4 screws; and through to the
battery with flanges; use the same passage as the original cabling (inside the exhaust pipe
protection (A)). (Clean the area thoroughly before attaching the plastic supports). When the
unit is connected to the battery, this will carry out a test of all the LEDs, displaying 88--bd and
then going off.
Detailed instructions
on power wiring assembly
1
27
EN
®
Wiring
supply
A