Circuit Board Error Code; Factory Reset; Declaration Of Conformity - Jaga BRIZA 22-JFCC Manuel

2.3. CIRCUIT BOARD ERROR CODE
RS485 A/B I2C
PC / RF CO2
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
CONTROL PANEL
Tsens 2
Tsens 3
THERMOSTATE 1
ON
Tsens 4
1 2 3 4 5 6 7 8
GND 0-10V 24V
GND 24V
DIPSWITCH
JAGA
GND 24V
GND NTC1 GND 0-10V +24V +24V RC GND IN/OUT GND 0-10V V.H.
2.4. FACTORY RESET
RS485 A/B I2C
PC / RF CO2
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
CONTROL PA CONTROL PANEL
Tsens 2
Tsens 3
THERMOSTATE 1 HERMOSTATE 1
ON
Tsens 4
N L
1 2 3 4 5 5 6 6 7 7 8 8
GND 0-10V 24V
GND 24V DIPSWITCH DIPSWITCH
JAGA JAGA
GND 24V
GND NTC1 GND 0-10V +24V +24V RC GND IN/OUT GND 0-10V V.H. GND 0-10V V.C.
3. DECLARATION OF CONFORMITY

DECLARATION OF CONFORMITY

JAGA N.V. - Verbindingslaan 16 - B 3590, declares under its sole responsibility that the
CEO JAGA N.V.
product to which this declaration relates:
Jan Kriekels
is in conformity with the following standards or documents provided that these are used in
accordance with our instructions:
60335-2-80 BASED ON EN 60335-2-80:2003 + A1:2004 + A2:2009
Following the provision of Directives as amended:
- Low Voltage 2014/35/EC
- EMC 2014/30/EC
- Machinery 2006/42/EC
26/03/2018
- RoHS 2011/65/EU
JAGA NV | BRIZA 22 - JFCC | MANUEL | 23.08.2021 | V.07
Error sensor [B]/[C] - Check the water temperature
sensor
Error sensor [J] - Check the room temperature sensor
N L
GND 0-10V V.C.
1. Disable power charge .
2. Press and hold down both the [-] and [+] button on the circuit board
and switch on the power again.
green LED 2 seconds later and
buttons as soon as all 3 LEDs are flashing .
3. The controller will return to the Factory settings, all LEDs will flash
for 10 seconds. The controller will return to the Factory Default settings, all
LEDs will flash for 8 seconds .
NBN EN 60335-1 BASED ON EN60335-1:2012 + A11:2014 / NBN EN
MODE 1 2 3
MODE 1 2 3
The blue LED will light up, followed by
the red LED 4 seconds later. Release the
BRIZA 12, BRIZA 22
EN
the
53