Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.2. SETTING FANSPEED
1. Select the mode that you want to adjust:
2. Short press [-] or [+] to adjust the preset speed.
1
-
The blue LED flashes quickly when
minimum speed is
FANSPEED %
20
25
30
35
3. After 30 seconds, the new settings are automatically saved and the device returns to the selected
mode.
2.3. CIRCUIT BOARD ERROR CODE
1
2.4. FACTORY RESET
1. Disable power charge.
2. Press and hold down both the [-] and [+] button on the circuit
board and switch on the power again. The
up, followed by the
green LED
4 seconds later. Release the buttons as soon as all 3 LEDs are
flashing.
3. The controller will return to the Factory Default settings, all LEDs will flash for 8 seconds.
JAGA NV | BRIZA 22 - JDPC.002 - US | MANUAL | 27200.20000096 | 11.02.2021 | V.02
-
+
Cooling
10 sec
the
reached.
40
45
50
55
blue LED
2 seconds later and the
/
Heating
The red LED flashes quickly when
maximum speed is reached.
70
60
65
75
Check the water temperature sensor
Check the room temperature sensor
1
will light
red LED
1
-
the
80
85
90
95
-
-
+
EN
100
-
+
7
Publicité
Table des Matières
