Water And Room Temperature Sensor - Jaga BRIZA 22 Instructions D'installation

B. WATER AND ROOM TEMPERATURE SENSOR
Only in combination with a suitable heat
pump and control valve for heating and
cooling!
RT WT
2 C
The device automatically enters cooling mode when the water temperature is 4°C/7°F below the
room temperature. If the differential between room and water temperature is less than 2°C/4°F, the
device will automatically switch to standby.
The device automatically enters heating mode when the water temperature is 4°C/7°F above the
room temperature. If the differential between room and water temperature is less than 1°C/2°F
higher than the room temperature, the device will automatically switch to standby.
Configuration code: DPC.BRC3
B.1. FACTORY SETTINGS
The unit automatically enters the desired operating mode ( or standby) based on the water and room
temperature.( , or standby).
Auto-change-over. The unit starts when the water temperature > 28 ̊ C /82 ̊ F .
Auto-change-over. The unit starts when the water temperature < 18 ̊ C /64 ̊ F .
The unit is in standby.
1 Speed. The unit runs at the preset speed.
JAGA NV | BRIZA 22 - JDPC.002 - US | MANUAL | 27200.20000096 | 11.02.2021 | V.02
RT WT
1 C
Standby mode
[C]
1
BLACK
WHITE
Not used
RT WT
1 C
KT : roomtemperatur- WT : watertemperature
4P
2P
24VDC
N L
Line voltage
(120V - 60Hz) Standard
(208V - 60Hz) HP
RT WT
4 C
5
EN