- 10V Bms With Water- And Room Temperature Monitoring - Jaga BRIZA 22-JFCC Manuel

B. 0 - 10V BMS WITH WATER- AND ROOM TEMPERATURE MONITORING
(AUTO-CHANGE-OVER)
Configuration code : FCC.BRC42 / FCC.BRC62 / FCC.BRC64
Only in combination with a suitable heat
pump and thermostat head for heating
and cooling
2⁰C
The device automatically enters the cooling mode as soon as the water temperature is 2
than the room temperature. If the water temperature is less than 1
the device will automatically switch to standby.
The unit is in standby. The unit automatically starts a new cycle as soon as the set temperature
has been reached.
The device automatically enters the heating mode as soon as the water temperature is 4
than the room temperature. If the water temperature is less than 1
re, the device will automatically switch to standby.
2-pipe
MODE
[F]
RS485 A/B I2C
PC / RF CO2
ON
1
GND 0-10V 24V
GND 24V
GND
GND NTC1 GND 0-10V +24V
[I]
44
1⁰C
[C]
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
[D]
CONTROL PANEL
Tsens 2
THERMOSTATE 1 Tsens 3
Tsens 4
N L
2 3 4 5 6 7 8
DIPSWITCH
JAGA
24V
+24V RC GND IN/OUT GND 0-10V V.H. GND 0-10V V.C.
[H]
N L
[A]
(200-240V - 50Hz)
JAGA NV | BRIZA 22 - JFCC | MANUEL | 23.08.2021 | V.07
1⁰C
Standby mode
° C lower than the room temperature,
°
C higher than the room temperatu-
4-pipe
MODE
[F]
2-pipe
[I]
RS485 A/B I2C
PC / RF CO2
POWER 45W
INPUT: 110-240VAC
OUTPUT: 24V
Tsens 1
CONTROL PANEL
Tsens 2
THERMOSTATE 1 Tsens 3
ON
Tsens 4
N L
1 2 3 4 5 6 7 8
GND 0-10V 24V
GND 24V
DIPSWITCH
JAGA
GND 24V
GND NTC1 GND 0-10V +24V +24V RC GND IN/OUT GND 0-10V V.H. GND 0-10V V.C.
[G] [H]
[A]
(200-240V - 50Hz)
4⁰C
°
C lower
°
C higher
4-pipe
[B]
4-pipe
[C]
[D]
N L