Publicité
Measuring Current
μA and mA measurement
Set up your multimeter to measure μA and mA as shown in
test and read the display.
– Press
NOTE
– For A measurement, set the rotary switch to
– For mA measurement, set the rotary switch to
– For A (ampere) measurement, set the rotary switch to
– Press
– Press and hold
– For measuring DC current from a mixed signal in the DC measurement
CAUTION
– For measuring AC current signals with a DC offset, refer to
Keysight U1253B User's and Service Guide
to cycle between DC, AC, AC+DC, and % scale current
measurements.
positive test lead to A.mA.
positive test lead to A.mA.
connect the positive test lead to A.
to display dual measurements. See
display with the Dual button"
available.
mode, ensure that the Filter is enabled (refer to
page 144).
and DC Signals"
on page 56.
on page 44 for a list of dual measurements
for more than 1 second to exit dual display mode.
Making Measurements
Figure
2-3. Probe the
, and connect the
, and connect the
, and
Table 1-8
of
"Selecting
"Setting the Filter"
"Measuring AC
2
on
57
Publicité
