Publicité
4
Changing the Default Settings
As another example,
– The F6 default function is changed from capacitance measurement to
– The F7 default measurement range for DC A is changed from Auto to 5000 A;
– The F8 default measurement range for DC mA is changed from Auto to 50 mA;
– The F8A default measurement range for DC A is changed from Auto to 5 A;
– The F9 default output values for pulse width and duty cycle are both changed
Figure 4-28
After making the desired changes, press
exit the EDIT mode.
If you reset the multimeter to its default factory settings (see
factory settings"
factory defaults.
140
Figure 4-28
temperature measurement;
from the 128th step (0.8333 ms for pulse width and 50.000% for duty cycle) to
the 255th step (1.6601 ms for pulse width and 99.609%).
Editing initial measurement function/range and initial output
values
on page 142), your settings for M-INITIAL will also revert to the
below illustrates that:
Edit initial functions
and ranges
to save the changes. Press
Keysight U1253B User's and Service Guide
"Returning to default
Publicité
