resideo R200 Guide D'installation Et De Configuration page 6

9. Carbon dioxide levels and guidelines
400 PPM
400 ~ 1000 PPM
>1000 PPM
>1200 PPM
>2000 PPM
>5000 PPM
10. Maintenance
We recommend to manually test CO
Dust is a major cause of false alarms. Therefore, clean the CO
cleaner to gently remove any accumulated dust along the sides of the CO
with a soft, slightly damp and lint-free cloth, making sure that no moisture enters the housing. Do not use
any sprays, solvents, alcohol-based cleaning agents or abrasive cleaners.
11. Warnings
This manual contains important safety information about the CO
Read the manual carefully and keep it in a safe place for future reference.
The monitor contains a permanently sealed, non-replaceable battery, and does not contain any
serviceable parts inside. Any attempt to open or repair it creates a risk of electric shock or malfunction.
Do not remove any safety signs, stickers or labels from the monitor.
Keep all safety signs, stickers and labels in a legible condition.
This product cannot be used in factories, warehouses and other industrial environments that may have
high CO concentration for a long period of time.
2
If the monitor is to be placed in a narrow space, the space should be well ventilated, especially the two
diffusion windows should be in a well-ventilated position.
The monitor should be away from heat source and avoid direct sunlight or other thermal radiation.
This product should not be used in environments with a high dust density for a long time.
Normal outdoor air level
Typical level indoors with good ventilation.
NOTE: If CO levels are low when building is sealed and occupied, check for
2
overventilation (too much fresh air = energy wasted).
ASHRAE and OSHA recommended maximum level in a closed room.
Considered maximum comfort level in many countries.
Poor air quality - requires ventilation.
According to many studies this level of CO
drowsiness, tiredness, headache lower levels of concentration and increased
likelihood of spreading respiratory viruses like colds, etc.
OSHA and NIOSH first threshold for safety. Maximum allowed concentration within
an 8 hour working period.
Monitor once a month by pressing and holding the test button.
2
produces a significant increase in
2
Monitor once a month. Use a vacuum
2
Monitor.
2
-6-
Monitor. Clean the device only
2