"Snooze" Function - 2measure 170101 Notice D'utilisation


Clock

Alarm clock with a snooze
STARTING THE DEVICE
Remove the protective film from the display prior to use.
Note: To avoid operating problems pay attention to polarity of alkaline batteries at inserting them (wrong polarity of
batteries may result in a permanent damage to the device).
Remove the plastic label on the back of base station.
The thermometer will show temperature in degrees Celsius once it is started.
SELECTING THE TEMPERATURE DISPLAY UNIT (°C/°F)
Press DOWN to set the required temperature unit: degrees Celsius or degrees Fahrenheit (°C/°F).
SETTING THE TIME

Press and hold SET for 3-4 seconds, indicating the format 12h or 24h starts flashing on the display.

Press UP to set format 12h or 24h.

Press SET the hour digits will start flashing on the display.

Press UP or DOWN to set the hour.

Press SET the minute digits will start flashing on the display.

Press UP or DOWN to set the minute.

Press SET the year digits will start flashing on the display.

Press UP or DOWN to set the year.

Press SET the month digits will start flashing on the display.

Press UP or DOWN to set the month.

Press SET the day digits will start flashing on the display.

Press UP or DOWN to set the day.

Press SET to go to Daylight Saving Time.

Press UP or DOWN to set the Daylight Saving Time.

Press MODE to return to the normal display mode.
SETTING THE ALARM

Press MODE to go to alarm setting mode , Press SET (for about 3 seconds) – hour digits will start flashing on
the display.

Set the required hour pressing UP or DOWN.

Press MODE or SET again – the minute digits will start flashing on the display.

Press UP or DOWN to set the minutes.

Press SET again, "Snooze" time will display.

Press UP or DOWN to set the" Snooze" time (1-60 minutes).

Press MODE to return to the normal display mode.

Press MODE to come back to "Snooze" time.

Press UP to turn on or off the alarm.

"SNOOZE" FUNCTION


Once the alarm activates, press SNZ to activate the snooze. "Z" will start flashing on the display.

Pressing SNZ during next alarms activates the Snooze again.

To stop the snooze, press SET or UP, the alarm remains active until it switches off completely.
SWITCHING THE ALARM ON/OFF

Press MODE to switch to alarm setting mode.

To switch the alarm on or off, press UP, bell symbol will appear when it is on.

Press MODE to return to normal display mode.
MINIMUM AND MAXIMUM TEMPERATURE

Press UP button to display the highest temperature (from the last weather station resetting). MAX caption will
be displayed at the temperature,

Press UP button again to display the lowest temperature (from the last weather station resetting). MIN caption
will be displayed at the temperature.

Press UP button again to come back to displaying the current temperature or wait 7-8 seconds until the
weather station automatically returns to displaying current indications. Max and Min symbols will disappear.

Weather station MIN/MAX temperature resets every day.
PRECAUTIONS:

Do not expose the device to strong vibrations and mechanical strain.

Avoid sudden and dramatic temperature changes (direct sunlight, low negative temperatures).

Clean the casing and the display with a soft and slightly wetted cloth.

Do not immerse the device in water.
4