Panasonic WH-SQC09H3E8 Manuel D'utilisation page 31

35. Service contact
Able to set name & tel no. of contact
person when there is breakdown
etc. or client has trouble. (2 items)
4 Service and maintenance
If forget Password and cannot operate remote controller
Press for 5 sec.
Password unlock screen appears, press Confirm and it shall
reset.
Password will become 0000. Please reset it again.
(CAUTION) Only display when it is locked by password.
Maintenance menu
Setting method of Maintenance menu
Maintenance menu
Actuator check
Test mode
Sensor setup
Reset password
Select Confirm
Press for 5 sec.
Items that can be set
1 Actuator check (Manual ON/OFF all functional parts)
(CAUTION) As there is no protection action, please be
careful not to cause any error when operating
each part (do not turn on pump when there is no
water etc.)
2 Test mode (Test run)
Normally it is not used.
3 Sensor setup (offset gap of detected temp of each sensor
within -2~2°C range)
(CAUTION) Please use only when sensor is deviated.
It affects temperature control.
4 Reset password (Reset password)
Service setup
Service contact:
Contact 1
Contact 2
Select
12:00am,Mon
12:00am,Mon Contact-1: Bryan Adams
ABC/ abc
A B C D E F G H I J K L M N O P Q R
S T U V W X Y Z
j k l m n o p q r s t u v w x y z
Confirm Select
Custom menu
Setting method of Custom menu
Custom menu
Cool mode
Back-up heater
Reset energy monitor
Select
Please press
Items that can be set
1 Cool mode (Set With/Without Cooling function) Default is
without
(CAUTION) As with/without Cool mode may affect electricity
application, please be careful and do not simply
change it.
In Cool mode, please be careful if piping is not
insulated properly, dew may form on pipe and
water may drip on the floor and damage the floor.
2 Back-up heater (Use/Do not use Backup heater)
(CAUTION) It is different from to use/not to use backup heater
set by client. When this setting is used, heater
power on due to protection against frost will
be disabled. (Please use this setting when it is
required by utility company.)
By using this setting, it cannot defrost due to
low Heating's setting temp and operation may
stop (H75)
Please set under the responsibility of installer.
When it stops frequently, it may be due to
insufficient circulation flow rate, setting temp of
heating is too low etc.
3 Reset energy monitor (delete memory of Energy monitor)
Please use when moving house and handover the unit.
0-9/ Other
a b c d e f g h i
Enter
12:00am,Mon
Confirm
for 10 sec.
31