Samsung RZ32 Serie Mode D'emploi page 55

A
B
A: 50 mm
B: 100 mm
13
Untitled-3 55
11
02
5. Attach the T10 PE foam (11).
- Attach the four T10 PE foam (11)
pieces to maintain a gap between the
refrigerator and the cabinet.
- Attach four foam pieces on each side
of the refrigerator which is adjacent
to a cabinet.
- See the figure for the position of the
foam.
NOTE
If you do not attach the foam, scratches
may occur if you push the refrigerator into
the cabinet.
6. Align the two refrigerators.
- Check the alignment at the top and
front of the refrigerators and realign
them if necessary.
7. Remove the screws from the two holes
where the lower bracket will be fastened
to.
- Open the door of the refrigerators
to be paired, and then remove the
screws located where the lower
bracket will be fastened.
8. Fasten the 7 mm lower bracket (02).
- Fasten the 7 mm lower bracket (02)
with the two M4 x 18 screws (13)
(one fastened to each refrigerator)
to secure the lower parts of the
refrigerators.
English 55
2020-11-05 AM 11:50:25