Honda Power Products HHHE61LE Notice D'utilisation page 24

MAINTENANCE
EN
WARNING:
other accessory may increase the risk of injury. To ensure safety and reliability, all
repairs should be performed by a Honda Dealer.
CLEANING
WARNING:
from the product when cleaning or performing any maintenance.
◾ ◾
Use a soft brush to remove debris from all air intakes and cutting blade.
◾ ◾
To remove pitch and other sticky residue, spray the blades with resin solvent.
Run the motor briefly so that the solvent is event distributed.
◾ ◾
Wipe the surface with a dry cloth.
WARNING:
when cleaning plastic parts. Most plastics are susceptible to damage from various
types of commercial solvents. Use clean clothes to remove dirt, dust, oil, grease, etc.
SHARPENING THE CUTTING BLADE
WARNING:
non-slip, heavy-duty protective gloves. Do not place your hand or fingers
between blades or in any position where they could get pinched or cut.
NEVER touch blades or service the unit with battery pack installed.
1. Start and stop your hedge trimmer
until the cutter blade and the guard
are slightly offset (Fig.10). This will
allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from you
hedge trimmer.
3. Clamp the blade assembly in a vise
and file the exposed cutting surface
of each blade tooth. Remove as little
material as possible. Be sure to retain
the original angle of each tooth when filing.
24
EN
CORDLESS HEDGE TRIMMER — HHHE61LE
When servicing, only use Honda approved parts. Use of any
To avoid serious personal injury, always remove the battery pack
Never use water for cleaning your trimmer. Avoid using solvents
Blades are sharp. When handling the blade assembly, wear
10
Cutter Tooth
Guard Tooth