Télécharger Imprimer la page

FLOS EXTRA T Mode D'emploi page 2

Publicité

ATTENZIONE!
La sicurezza dell'apparecchio è garantita solo rispettando
queste istruzioni sia in fase di installazione che di impiego;
è pertanto necessario conservarle.
AVVERTENZE:
- All'atto dell'installazione ed ogni volta che si interviene
sull'apparecchio, assicurarsi che sia stata tolta la tensione
di alimentazione.
- L'apparecchio non può essere in alcun modo modificato
o manomesso, ogni modifica ne può compromettere la
sicurezza rendendo lo stesso pericoloso. FLOS declina
ogni responsabilità per i prodotti modificati.
- L'apparecchio è esente dal rischio di emissione
fotobiologica.
- La sorgente luminosa non può essere sostituita dal
cliente. Per informazioni contattare FLOS.
- Se il cavo flessibile si danneggia, deve essere sostituito
da FLOS o da personale qualificato al fine di evitare pericoli.
- Il simbolo
riportato sull'apparecchio indica che il
prodotto deve essere smaltito in modo differenziato dai
rifiuti urbani.
DATI TECNICI
- Nr. 1 LED 16W
ISTRUZIONI PER LA PULIZIA DELL'APPARECCHIO
- Per la pulizia dell'apparecchio utilizzare esclusivamente
un panno in MICROFIBRA. Attenzione: non utilizzare
alcool o solventi.
WARNING!
The safety of this fitting can only be guaranteed if these
instructions are observed, during both installation and
use. Please retain these instructions safety.
REMARKS:
- When installing and whenever acting on the appliance,
ensure that the power supply has been switched off.
- The appliance may in no way be modified or tampered
with. Any modification may compromise safety and
making the appliance itself dangerous. FLOS declines all
responsibility for products that are modified.
- The device carries no risk of photobiological emissions.
- The light source cannot be replaced by the customer.
Contact FLOS for information.
- Should the external trailing cable get damaged, it must
be replaced by FLOS or by qualified personnel in order to
avoid any danger.
- The symbol
shown on the device indicates that the
product must be disposed of in a different manner than
with the urban waste.
TECHNICAL DATA
- Nr. 1 LED 16W
CLEANING INSTRUCTIONS
- To clean the device use only a MICROFIBRE cloth. Warning:
do not use alcohol or other solvents.
2
ACHTUNG!
Wir garantieren nur dann für die Sicherheit der Leuchte,
wenn diese Anweisungen sowohl bei der Installation als
auch beim Gebrauch genau beachtet werden. Es ist daher
ratsam, sie aufzubewahren.
BEMERKUNGEN:
- Bei der Installation und bei Eingriffen an der Leuchte ist
sicherzustellen, daß die Anlage vom Netz abgeschaltet ist.
- Der Apparat darf auf keinen Fall veraendert oder
unerlaubt geoeffnet werden, jede Veraenderung
desselben kann die Sicherheit in Frage stellen und somit
gefaehrlich werden. FLOS lehnt jede Verantwortung fuer
unsachgemaess behandelte Produkte ab.
- Das Gerät ist frei von photobiologischen Emissionsgefahren.
- Die Leuchtquelle kann nicht vom Kunden ausgewechselt
werden. Für Informationen bitte FLOS kontaktieren.
- Falls das flexible äußere Kabel beschädigt wird, muß
es von FLOS oder von qualifiziertem Personal ersetzt
werden, um Gefahren zu vermeiden.
- Das auf dem Gerät wiedergegebene Symbol
an, dass das Produkt getrennt vom Stadtmüll entsorgt
werden muss.
TECHNISCHE DATEN
- Nr. 1 LED 16W
REINIGUNGSVORSCHRIFTEN
- Zur Reinigung des Geräts ausschließlich ein Tuch aus
MIKROFASERN verwenden. - Achtung: Weder Alkohol noch
Lösungsmittel verwenden.
ATTENTION!
La sûreté de cet appareil est garantie uniquement si l'on
respecte ces instructions soit en phase d'installation soit
pendant l'utilisation; il faut donc les conserver.
NOTICES:
- Au moment de l'installation et chaque fois que l'on intervient
sur l'appareil, s'assurer que la tension d'alimentation a été
coupée.
- L'appareil ne peut être modifié ou altéré de quelque
manière que ce soit, toute modification peut compromettre
sa sécurité en le rendant dangereux. FLOS décline toute
responsabilité sur les produits modifiés.
- L'appareil ne présente aucun risque photobiologique.
- La source lumineuse ne peut pas être remplacée par le
client. Pour obtenir des informations, contacter la société
FLOS.
- Si le cordon flexible externe est endommagé, il doit être
remplacé par FLOS ou par le personnel qualifié afin d'éviter
des dangers.
zeigt
- Le symbole
montré sur l'appareil indique que le
produit doit être éliminé d'une autre façon que celle avec
les déchets urbains.
DONNEES TECHNIQUES
- Nr. 1 LED 16W
INSTRUCTIONS POUR LE NETTOYAGE
- Pour nettoyer l'appareil, utiliser exclusivement un
chiffon en MICROFIBRE. Attention: ne pas utiliser d'alcool
ou solvents.
3

Publicité

loading