GE JV535 Manuel Du Propriétaire Et Instructions D'installation page 12

REMOVE DUCT KNOCKOUT(S)
6
If recirculating, non-vented ductless (optional for
JV5 Series models only), see note below and skip to
recirculated.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood.
" x 10" Rectangular
3
1 4
vertical discharge.
Remove top rectangular
duct knockout only.
NOTE: If the hood is to be installed in a recirculating, non-
vented ductless manner, order charcoal filters,
These kits can be ordered from your GE supplier.
Skip to Step 9 D and proceed.
Installation Instructions
7" Round vertical discharge.
Remove semi-circular duct
knockout and top rectangular
duct knockout.
" x 10" Rectangular horizontal
3
1 4
discharge. Remove rear
rectangular duct knockout only.
" hood models, or
hood models.
"
" x 10" RECTANGULAR
FOR 3
7
1 4
DUCTED DISCHARGE INSTALLATIONS
ONLY:
Attach
damper pivot is nearest to
Remove tape from damper flap.
Up to 1" side-to-
side adjustment
Pivot
NOTE:
up to 1 inch on either side of the hood center to
installations, one end of the duct connector may need to
be trimmed to clear the electrical cable clamp.
FOR 7" ROUND VERTICAL DUCTED
8
DISCHARGE INSTALLATIONS ONLY:
" round exhaust adaptor with its
screws, removed in Step 2 under the "Prepare the
Hood" section.
"
NOTE:
up to 1 inch on either side of the hood center to
installations, one end of the duct connector may need
to be trimmed to clear the electrical cable clamp.
NOTE: The 7" round damper is not included with
this product. It can be purchased as a kit by calling
12
over knockout
of hood.
Top/back edge
(vertical discharge
position shown)
" round
adaptor
Tape