GE JV535 Manuel Du Propriétaire Et Instructions D'installation page 11

REMOVE EXHAUST ADAPTOR
2
"
the hood. Set it aside along with its mounting screws.
NOTE: Save the screws for 3-1/4"
ducted installation, if that is your chosen venting option.
" round
adaptor
REMOVE FILTERS
3
Remove the protective shipping film from the edges
of the metal grease filters. Press the filter locks back
and lift the filters out. Set them aside.
Filters
Installation Instructions
" rectangular
11
REMOVE WIRING COVER
4
Remove the wiring cover from inside the hood.
Set the cover and its mounting screw aside.
Wiring
cover
REMOVE WIRING KNOCKOUT
5
Remove either the top or the back wiring knockout as
needed and install an approved strain relief clamp.
Strain relief
clamp