Cleaning And Maintenance; Technical Data - VOLTCRAFT 10 10 61 Mode D'emploi

CLEANING AND MAINTENANCE

You do not need to service the product, apart from occasional cleaning. The ball bearing on the
sliding reel should be lubricated occasionally with oil or grease. Use only non-resinous and
acid-free grease or oil.
Use a soft, antistatic and lint-free cloth for cleaning.
Do not use abrasive or chemical cleaners.
Carefully rinse the gooseneck of the Endoscope with clean water, after use in liquids, and dry
it before storing it for the next use.
DISPOSAL
Electronic devices are recyclable waste and must not be disposed of in the
household waste! Please dispose of the device when it is no longer of use,
according to the current statutory requirements.

TECHNICAL DATA

Image sensor: ..............................CMOS
Illumination: ..................................12 white LEDs
Exposure:......................................automatic
White comparison: ........................permanently set
Operating/storage temperature:....-20 to +60 ºC
Min. bending radius: ....................100 mm
Protection type: ............................IP67
Camera Ø: ....................................28 mm
Length:..........................................Item-No. 101061: 3 m
Item-No. 101063: 10 m
Item-No. 101064: 25 m
You can find the professional base unit BS-1000T required at conrad.com
Order No: 12 33 19
Impressum /legal notice in our operating instructions
These operating instructions are a publication by Voltcraft
(www.voltcraft.de).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing
systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2012 by Voltcraft
®
, Lindenweg 15, D-92242 Hirschau/Germany, Phone +49 180/586 582 7
®