ABB PSE18 Manuel page 6

3 Mounting
The PSE Softstarters exist in three different physical sizes which are
designed to be mounted with M6 bolts, or bolts of equivalent dimension
and strength.
1. Identify the correct drawing with dimensions for your softstarter
2. Verify the drilling plan.
3. In applications where the softstarter is installed in an enclosure, make
sure that the enclosure size is not smaller than the minimum recom-
mended. Select size from the applicable table for IEC or
4. Check that the distance to wall and front, as well as the mounting
angle fulfills the requirements.
5. Ensure a free flow of air through the product.
Risk of damage to property. Ensure that no liquids, dust or conductive
parts enter the softstarter.
Using a too small enclosure and/or failure to follow the instructions in
other ways, may result in overheating of the PSE Softstarter and opera-
tional disturbances.
6 Softstarters Type PSE18...PSE370 User Manual short form 1SFC132369M9901
03
04
05
.
06
07