Murray 425307x51A Manuel De L'opérateur page 11

Assembly
13. Attach the gauge wheels (12) to the axle bolts (11)
with the fasteners (see Figure 3).
14. Check the operation of the blade rotation control.
See "Adjust the Blade Rotation Control."
11
12
Install the Seat
1. Carefully remove the plastic bag from the seat.
2. Align the holes in the seat hinge (2) to the holes in
the seat (1) (see Figure 4). Fasten the seat to the
seat hinge with the fasteners (4) and (5).
3. Check the operating position of the seat. If the seat
needs to be adjusted, loosen the two wing bolts (5).
Slide the seat forward or backward along the seat
adjusting holes (3).Tighten the wing bolts.
3
4
Assemble the Steering Wheel
1. Make sure the front wheels point forward.
2. Slide the cover (3) over the steering post (2) (see
Figure 5). Make sure the collar of the cover is on top.
3. Slide the steering wheel (1) onto the steering post.
4. Attach the steering wheel to the steering post with
screw (4) and washer (6).
5. Some models have an optional insert (7) in the parts
13
bag. Attach the insert to the center of the steering
wheel.
Figure 3
1
2
5
Figure 4
en
7
4
6
1
3
2
Figure 5
11