Murray 425307x51A Manuel De L'opérateur page 10

Assembly
Assemble the Mower Housing
1. Move the blade rotation control (1) to the
DISENGAGE position (see Figure 2).
2. Move the lift lever (2) to the level adjustment
position.
WARNING
The lift lever is spring loaded. Make sure the lift
lever is locked in the LEVEL ADJUSTMENT
position.
3. Attach the front hanger (9) to the deck with the
fasteners. See illustration "F."
4. Push the mower housing under the right side of the
unit.
5. Put the mower drive belt (7) around the stack pulley
(8). See illustration "G."
NOTE: Make sure the "V" side of the mower drive belt
is against the stack pulley. Also, make sure the
mower drive belt is not twisted.
(31x4)
A
(17x91)
B
3
(31x4)
C
(17x91)
10
2
4
1
(31x4)
A
B
(17x91)
4
C
11
(31x11)
11
12
(17x91) 12
6. Attach the front hanger to the axle support.
See illustration "F."
7. Make sure the mower drive belt is between the stack
pulley and the two belt guides (10).
See illustration "G."
8. Attach the suspension links (4) to the lifter assembly.
Fasten with the hair pins and washers. See illus-
trations "A" and "B."
9. Attach the right and left adjuster arms (3) to the
suspension brackets. Fasten with the hair pins and
the washers. See illustrations "C" and "D."
10. Attach the extension spring (5) to the blade control
rod (6). See illustration "E."
11. Move the blade rotation control to the ENGAGE
position. Make sure the mower drive belt is inside
all the belt guides.
12. Make sure the mower housing is level. See "Level the
Mower Housing."
G
E
D
7
7
13
13
9
8
8
10 7
10
10
7
D
(17x91)
5
5
6
F
F
en
3
(31x4)
6
E
Figure 2