DeWalt DW682 Guide D'utilisation page 17

383956-00,02,DW682 4/21/04
E. Make the plunge cut and repeat for all biscuit locations.
F. Glue, assemble and clamp the joint.
G. For joints other than 90° see inside registration column in
Figure 27 for proper fence angle setting.
6. T-JOINTS (FIGURE 29)
Biscuit joining is a viable alternative to dadoing when making a T-
joint. T-joints are most commonly used when attaching shelves to
the sides of a case. The method described below will work if your
shelf material is at least 5/8" thick.
A. Place the workpieces on a work surface exactly as you will be
assembling them in the form of an upside down "T." Mark lightly
along the joint where the top of the shelf is to end up (see
Figure 30). Mark biscuit locations at the joint interface on the
shelf piece only.
B. Lay the shelf down on the mating workpiece. Clamp the two
workpieces together and to the work surface in this position
(see Figure 31).
C. Set up the tool by selecting the proper biscuit size and setting
the adjustable fence angle at 0°.
D. Using the bottom registration surface, align the tool with the
biscuit location marks and make a vertical and a horizontal
plunge cut for each biscuit location as shown in Figure 32.
E. Glue, assemble and clamp the joint.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, please
contact your local dealer or authorized service center.
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous.
8:20 AM Page 14
Motor Brushes
D WALT uses an advanced brush system which automaticallystops
E
the drill when the brushes wear out. This prevents serious damage to
the motor.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty materials
E
or workmanship for three years from the date of purchase. This
warranty does not cover part failure due to normal wear or tool abuse.
For further detail of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
warranty does not apply to accessories or damage caused where
repairs have been made or attempted by others. This warranty gives
you specific legal rights and you may have other rights which vary in
certain states or provinces.
In addition to the warranty, D
E
1 YEAR FREE SERVICE
D WALT will maintain the tool and replace worn parts caused by
E
normal use, for free, any time during the first year after purchase.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of your
D WALT Power Tool, Laser, or Nailer for any reason, you can return it
E
within 90 days from the date of purchase with a receipt for a full refund
– no questions asked.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-DEWALT for a free
replacement.
14
WALT (1-800-433-9258). This
E
WALT tools are covered by our: