jablotron BM-02 Mode D'emploi page 15

3. Attach the evaluation unit to the crib (pram, etc.) with a fastening tape.
The unit must be clearly visible and must not be covered by anything – see Fig B.
If the evaluation unit has to be mounted outside the crib, extend its cable by means of the splitting connec-
tor and the 5 m long cable (both are included in the supply).
When used for a bigger baby, mount the unit outside her reach.
It is also possible to attach the unit on the wall by means of a plastic holder (included in the supplied items).
4. Connect the sensor pad's cable to the evaluation unit. When connected properly, the connector clicks and
is fi rmly attached.
Lead the cable so that it cannot be pulled by a bigger child and so that it is stretched properly and does not
create loops.
If the whole length of the cable is not used, wind the excess cable and tighten it fi rmly with the binding wire
supplied with the cable (keep the wound cable outside the reach of children).
To disconnect the cable from the evaluation unit push the connector lever towards the cable.
Caution:
The acoustic indicator of the breath monitoring unit must not be aimed at the baby and must be placed at
least 0.5 m from her head to protect her hearing from possible damage.
THE NANNY'S SIGNALING AND CONTROL ELEMENTS
green indicator – it fl ickers briefl y to confi rm the baby's breath (movement).
red indicator – it fl ickers to indicate a warning alarm.
red indicator – it fl ickers to indicate a low battery.
USING THE BM-02 NANNY MONITOR
Before using the BM-02 Nanny read this manual carefully, especially paying close attention to the chapter
"First Aid – General Procedures of Emergency Child Care"!
1. Put the baby in the crib.
2. Turn on the evaluation unit (activation is confi rmed by a beep and fl ickering indicators).
3. The green indicator fl ickers in response to the baby's breathing or movements. The fl ickering may be irre-
gular – its frequency corresponds to the baby's breathing or movements.
4. Before taking the baby out of the crib make sure to turn the evaluation unit off.
5. If the device does not detect any breathing or movement of the baby, the green indicator does not fl icker,
a red indicator begins to fl icker after approx. 20 seconds and then the alarm goes off. Moreover, the alarm
is activated when the baby's breathing frequency drops below 8 breaths per minute.
Warning:
The product should be used for babies weighing from 2 kg up to 15 kg.
EN
switch – position 0 = OFF, I = ON
15
MFV52110