Bosch GBH 2-24 DFR Instructions D'emploi page 10

Product Specifications
Percussion drill
Order number
Replacement drill chuck
Speed control
Right/Left rotation
Rated input power
Power output
Impact rate
Impact energy
per stroke
Nominal speed
Right rotation
Left rotation
Tool holder SDS-plus
Spindle collar diameter
Number of chiselling positions
Maximum drill diameter:
Concrete/Stone
Granite
Wood
Steel
Weight (without acces-
sories) approx.
Degree of protection
Product Elements
1 13 mm Quick clamping replacement drill chuck
2 SDS-plus replacement drill chuck
3 Tool holder (SDS-plus)
4 Dust protection cap
5 Locking sleeve
6 Replacement drill chuck locking ring
7 Locking button
8 On-off switch
9 Right/Left rotation switch
10 Unlocking button
11 Operational mode selection switch
12 Auxiliary handle
13 Drill bit holder
Not all the accessories illustrated or described are in-
cluded in standard delivery.
1 619 929 413 • (01.06) T
GBH 2-24 DFR
0 611 238 7..
q
q
q
[W] 620
[W] 360
[per min] 0 ... 4850
[J] 2.2
[RPM] 0 ... 870
[RPM] 0 ... 500
q
[mm] 43
(Euro-Standard)
36
[mm] 24
[mm] 16
[mm] 30
[mm] 13
[kg] 2.6
/ II
Noise/Vibration Information
Measured values determined according to EN 50 144.
The A-weighted noise levels of the tool are typically:
Sound pressure level: 88 dB(A)
Sound power level: 101 dB(A)
Wear ear protection!
The typical weighted acceleration is 11 m/s
Intended Use
The machine is intended for hammer drilling in con-
crete, brick and stone as well as for light chiselling
work. It is also suitable for drilling without impact in
wood, metal, ceramic and plastic.
Machines with electronic control and right/left rotation
are also suitable for screw driving and thread cutting.
In addition, the general safety instructions in the
enclosed booklet must be followed.
Before using for the first time, ask for a practical
demonstration.
Connect machines that are used outdoors by
s
means of a fault current protection switch (FI) with
a maximum triggering current of 30 mA. Use only
an extension cable that is approved for outdoor
use.
Always direct the cable to the rear away from the
s
machine.
Insert the mains plug into the socket only when the
s
machine is switched off.
Place the machine on the nut/screw only when
s
switched off.
For screws, work using the first gear or with a low
s
speed.
Be careful when screwing in long screws; danger
s
of sliding off.
When working with the machine, always hold it
s
firmly with both hands and provide for a secure
stance.
English–1
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
If the cable is damaged or cut through
while working, do not touch the cable
but immediately pull the mains plug.
Never use the machine with a dam-
aged cable.
Wear ear protection to prevent damage
to your hearing.
Wear safety glasses and sturdy shoes.
For long hair, wear hair protection.
Work only with close-fitting clothes.
2
.