R&G PKS0021 Instructions De Montage

FITTING INSTRUCTIONS FOR PKS0021 KICKSTAND SHOE
Please note that the way the kit is packed does not necessarily represent the way of
T
HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY
Please note that in cases where kits are packed with rubber washers holding the components onto the
FITTING INSTRUCTIONS

Place the clamp plate (pictured above right) over the side stand base and position up the side
stand shaft with the counter-sinks upper-most.

Take the aluminium machined base plate (picture above left) and fit to the base of the side
stand from underneath so it is aligned with the clamp plate.

Use the three counter-sunk bolts to secure in position, ensuring the inside edge of the clamp
plate clamps down on the top of the side stand base

Tighten all bolts evenly and check to ensure the side stand pad clears the chain when in the
raised position.
BMW F800 GT '13-
mounting to the bike.
bolt – the rubber washers should be thrown away!
BASE PLATE
TOOLS REQUIRED

3mm A/F Allen key.
(
FOR CLARITY OF INSTRUCTIONS ONLY
CLAMP PLATE AND BOLTS
)