Preparing The Transmitter - Radiodetection RD8100 Guide D'utilisation

Preparing the locator:
1. Press the key to enter the menu.
2. Scroll to the BT menu using the
3. Press the key to enter the BT menu.
4. Scroll to the PAIR menu and press the
5. Scroll to the BT-TX option.
NOTE: You must complete the pairing process within 90 seconds to prevent the
locator's Bluetooth connection from timing out.

Preparing the transmitter:

6. Press the key to enter the menu.
7. Scroll to the BT menu using the
8. Press the key to enter the BT menu.
9. Scroll to the PAIR option.
Starting the pairing process:
10. Press the key on the transmitter followed by the
11. The transmitter and the locator will now attempt to pair.
When pairing is in progress, the transmitter and locator will display a flashing Bluetooth
icon. Pairing can take up to a minute. If the pairing process is successful, the transmitter
will display the icon and the locator will display a persistent Bluetooth icon for the
duration of the connection.
If pairing fails, ensure that any nearby Bluetooth devices are switched off or invisible then
repeat the process.
Once the locator and transmitter have successfully paired you can use iLOC to change the
transmitter's output frequency and power levels remotely from the locator.
Using iLOC
The locator and transmitter need to
be paired to use iLOC. For optimum
performance:
• Try to minimize obstructions in line of
sight.
• If possible, raise the transmitter off the
ground by 30-60cm (1-2ft).
• Face the rear end of the transmitter
towards the locator.
• Point the screen of the locator towards
the transmitter.
or keys.
key to enter it.
or keys.
24
key on the locator.