Radiodetection RD8100 Guide D'utilisation page 10

Keypad actions and shortcuts
Switch the locator or transmitter on by pressing the
function as follows:
Locator keys
K EY
●
Enter the menu
Scroll through locate frequencies
from low to high
When using active frequencies:
Toggles Peak, Peak+, Null, Broad Peak
and Guidance antenna modes.
In Power Mode:
Scrolls through Power Filters
discrimination of parallel or strong power
signals
Increase and decrease gain.
RD8100 automatically sets gain to
and
mid-point when pressed
Take a Survey Measurement and send
over Bluetooth if paired
Send an iLOC command to a paired
transmitter
Transmitter keys
K EY ●
Enter the menu
Scroll through locate frequencies
from low to high
Take voltage and impedance measurements
using the currently selected frequency
Adjusts the output signal
and
Tip: to scroll through frequencies from high to low, hold
(applies to both locators and transmitters).
S H O R T P R E S S
S H O R T P R E S S
key. Once powered up, the keys
● ■ ■ ■ ●
Switch power off
SideStep
When using Current Direction
Perform a CD Reset
In Peak+ antenna mode:
Switch between Guidance and Null arrows
for improved
™
Rapidly increase and decrease gain steps
in 1dB increments
–
Enter the Transmitter power setting menu
for use over iLOC
● ■ ■ ■ ●
Switch Power off
–
Take voltage and impedance
measurements at a standardized frequency
Select standby
power
while pressing the
10
LON G P R E S S
(see 'iLOC' section)
™
:
™
LON G P R E S S
/ maximum standard
button