Radiodetection RD8100 Guide D'utilisation page 21

Bluetooth error codes
If an error occurs when attempting to perform any Bluetooth command using the locator
to the transmitter or the locator to a PC or PDA, the LCD will display a code to help you
resolve the problem on the locator.
The codes are as follows:
B T CO D E D E S CR I P T I ON
BT001 Bluetooth not configured for this unit
BT002 Internal Bluetooth error
BT003 Locator not paired with transmitter
BT004 Locator not paired with PC/PDA
BT005 Paired but connection attempt failed. Power cycling may be required
BT006 Corrupt response received from transmitter
BT007 Indeterminate response received from transmitter
BT008 No response received from transmitter
TX?? Transmitter unable to change to the requested frequency
Taking Survey Measurements
RD8100 locator models are capable of recording measurements at up to 1000 survey
points, and optionally sending them to an external device using Bluetooth.
If the locator is a GPS model or if paired to a PDA with GPS that is running a compatible
application such as SurveyCERT the locator will append positional information alongside
time and date to the data, providing spatial context.
NOTE: The internal GPS module needs to be switched on and connected to the
GPS satellite system.
Saving measurements
To save survey measurements, press the
To achieve accurate results the locator must be kept as still as possible during the saving
process.
The locator will always save measurements to internal memory. If Bluetooth is switched
on, paired to a device and BT-PC is enabled, the locator will also attempt to send
the saved measurement to a paired PDA running SurveyCERT or to a PC running a
compatible application.
Erasing measurements
The RD8100 locator allows you to delete all measurements. Erasing the log will wipe the
RD8100 memory and is usually recommended when you begin a new survey.
key.
21