DeWalt DW004 Serie Mode D'emploi page 30

E N G L I S H
• Apply only a gentle pressure to the tool.
• Do not drill or drive too deep to prevent
damage to the dust cover.
Switching on and off (fig. A)
• To run the tool, press the variable speed switch
(1). The pressure exerted on the variable speed
switch determines the tool speed.
• To stop the tool, release the switch.
Hammer drilling (fig. A)
• Select the hammer drilling mode.
• Insert the appropriate SDS-plus bit. For best
results use high quality carbide-tipped bits.
• Mark the spot where the hole is to be drilled.
• Press the tool against the workpiece.
• Switch the tool on by pressing the variable speed
switch (1). The hammer mechanism should run
smoothly and the tool should not bounce.
If necessary, increase the pressure on the switch.
Rotary drilling (fig. A)
• Select the rotary drilling mode.
• Proceed as described for hammer drilling.
Special SDS-plus adaptors with threaded sections
are available for use with standard 10 or 13 mm
chucks to enable straight shank bits to be used.
Never use standard chucks in the
hammer drilling mode.
Chipping and chiselling (fig. A)
• Select the hammering only mode.
• Insert an SDS-plus® chisel and check if it is
properly locked.
• Adjust the side handle (4) as required.
• Proceed as described for hammer drilling.
It may be necessary to briefly run the motor after
having changed from chiselling to rotary modes in
order to align the gears.
Screwdriving (fig. A)
• Select the rotary drilling mode.
• Select the direction of rotation.
• Insert the special SDS-plus screwdriving adaptor
for use with hexagonal screwdriver bits.
• Insert the appropriate screwdriver bit into the
adaptor. When driving slotted head screws
always use bits with a finder sleeve.
30
• Gently press the variable speed switch (1) to
prevent damage to the screw head.
• When the screw is flush with the workpiece,
release the variable speed switch to prevent the
screw head from penetrating into the workpiece.
• Do not use this tool to mix or pump
easily combustible or explosive fluids
(benzine, alcohol, etc.).
• Do not mix or stir inflammable liquids
labelled accordingly.
Various types of SDS-plus drill bits and adaptors are
available as an option. Consult your dealer for further
information on the appropriate D
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
• The rotary hammer drill is not user-serviceable. Take
the tool to an authorized D
This tool should be serviced at regular intervals or
when showing a noticeable change in performance.
Lubrication
Your power tool requires no additional lubrication.
Always apply a small amount of grease
to the shank of the SDS-plus bit before
inserting it into the tool holder.
Cleaning
• Unplug the charger before cleaning the housing
with a soft cloth.
• Remove the battery pack before cleaning your
Power Tool.
• Keep the ventilation slots clear and regularly
clean the housing with a soft cloth.
WALT accessories.
E
WALT repair agent.
E