Operation; Heat And Blower Levels - SilverCrest SHTK 2000 B1 Mode D'emploi

ATTENTION! DAMAGE TO PROPERTY!
Never pull the power cord out of the device beyond the point
►
indicated with a red mark.
Always pull the power cord out of the device up to the point
►
indicated with a red mark when you use the device. Otherwise it
GB could overheat!

Operation

NOTE
► Before use, pull the plug out of the device up to the point indicated with a
red mark!

Heat and blower levels

26
1) Insert the plug into a power socket.
2) Switch the hair dryer on with the blower level switch 5.
The hair dryer is fi tted with two function switches. With these you can separately
select the strength of the air fl ow (blower level switch 5) and the level of heat
(heat level switch 6):
Blower levels
O The hair dryer is switched off
reduced air fl ow
full power air fl ow
Heat levels
cold air fl ow
low heating level
high heating level
3) After use, switch the appliance off in that you place the blower level switch 5
into position "O". Then remove the plug from the wall socket.
4) Press the cord retract button 2 to feed the cord back into the device.
SHTK 2000 B1