Before Straightening; Automatic Switch-Off; Operation; Switching On/Off - SilverCrest SHG 32 B1 Mode D'emploi

Before straightening

■ The hair should be clean, dry and free of styling products. The only exception
to this are special products which facilitate hair straightening.
■ Comb the hair thoroughly before straightening so that there are no knots in it.
Automatic switch-off
This appliance is fitted with an automatic switch-off system. After 30 minutes, the
appliance will switch itself off automatically. After approx. 25 minutes the indicator
lamp starts to flash, to remind you it is about to switch off automatically. If you
want to continue using the appliance, switch it off for a moment and then back
on again.
NOTE
► The automatic switch-off is a safety function only and is not intended as
a replacement for switching the appliance off properly using the on/off
switch

Operation

Switching on/off
NOTE
► The hotplates
(see section "Cleaning").
The appliance is secured with the catch
pull the catch
1) Insert the plug into a mains power socket.
2) To switch the appliance on, slide the ON/OFF switch
indicator light
about 1 minute, the hair straightener will have heated up and the indicator
light
3) When you have finished styling your hair, push the ON/OFF switch
backwards (Off). The indicator light
the appliance to cool down completely.
■ 26 │
GB
!
must be free of dirt. Clean them before use if required
out. Now you can open the hair straightener all the way.
starts to flash red and the appliance starts to heat up. After
lights up red.
. Press the hotplates
forwards (On). The
goes out. Pull out the plug and allow
together and
SHG 32 B1